Filter
Top Products
4-5 Cutter Installation Method 2 (No Nose Unit)
65
Chapter 4 Engraving
➌
Secure the cutter in place.
Tighten the mounting screw for the cutter
holder.
➍
Press .
➎
Use and to select [Z0].
➏
Press to confirm.
The Z-axis origin is set.
➐
Press .
The main display appears. The coordinate values for Z is set to 0.
This completes the installation of the cutter. Go on to page 75, “Setting the XY Origin Point (Home Position)."
If cutter insertion is difficult
If the cutter catches on the solid collet and is difficult to
insert, loosening the cutter holder makes insertion easier.
Note that inserting it with undue force may result in
damage to the workpiece. After inserting the cutter,
tighten the cutter holder again.
When using a diameter-4.36 mm solid collet
Be careful to orient the cutter correctly.
Loosen the cutter holder.
Cutter
Solid collet
Tab
Tab
Cutter holder
Hexagonal
screwdriver
Mounting screw