Filter
Top Products
3-6 Pausing and Stopping Cutting
50
Chapter 3 Basic Operation
Important!
Before opening the front cover while operation is paused, first make sure that rotation of the spindle is stopped. For
safety, opening the front cover while the spindle is turning makes the machine perform an emergency stop. Be sure to
note that if this happens, it’s necessary to quit the operation and start over from the beginning.
☞ P. 39, “Emergency Stop Due to Opening or Closing the Front Cover”
Other operations possible while paused
➢ Starting or stopping spindle rotation
☞ P. 47, “Starting and Stopping Spindle Rotation”
➢ Changing the spindle speed
☞ P. 48, “Adjusting the Spindle Speed”
➢ Changing the feed rate of the cutter
☞ P. 77, “Adjusting the Cutter Feed Rate During Engraving (Override)”
Stopping Cutting
This stops cutting through operation using the handy panel. Unlike pausing operation, cutting cannot be resumed.
Procedure
➊
While cutting is in progress, press .
Movement of the cutter pauses. Rotation of the spindle does not
stop at this time.
The display screen shown at left appears.
➋
➀
Use to select “STOP.”
➁
Press to confirm.
The cutter moves to the highest location on the Z axis, then stops.
If the spindle is rotating, its rotation stops here.
➀➁