Filter
Top Products
4-4 Cutter Installation Method 1 (With Nose Unit)
61
Chapter 4 Engraving
Important Notes When Using the Nose Unit
Amount of Height Displacement That Can Be Tracked
When automatic Z control is set to “ON,” then as long as the tip of the nose unit is in contact with the surface of the
workpiece, the cutting-in depth can be kept uniform even if the height of the material changes. However, there is an
upper limit to the amount of height displacement that can be tracked. Before you do the actual engraving, carry out an
engraving test to make sure the desired engraving can be accomplished.
(Trackable undulation height: gentle undulations of about 1 millimeter)
Limitations on Cutting
Care is needed when performing fill engraving (flat-drag cutting inside the contour lines of characters and shapes) over
a wide surface area. With fill engraving that is broader than the diameter of the nose unit, the nose unit may track the
surface that has already been cut and cut the surface further.
8 mm
Nose unit