Filter
Top Products
4-4 Cutter Installation Method 1 (With Nose Unit)
59
Chapter 4 Engraving
4.
Install the cutter and make the setting for the cutting-in depth.
➊
Use , , , and to
move the spindle head to the area above
the workpiece, then press
to
lower the spindle head.
Descent stops automatically when the tip of
the nose unit touches the workpiece table.
☞ P. 44, “Manual Movement”
➋
Insert the cutter into the cutter holder
and bring the tip of the cutter into con-
tact with the workpiece table.
If cutter insertion is difficult
If the cutter catches on the solid collet and is difficult
to insert, loosening the cutter holder makes insertion
easier. Note that inserting it with undue force may re-
sult in damage to the workpiece. After inserting the
cutter, tighten the cutter holder again.
When using a diameter-4.36 mm solid collet
Be careful to orient the cutter correctly.
Cutter
Solid collet
Workpiece table
Cutter
Cutter holder
Workpiece table
Loosen the cutter holder.
Tab
Tab