Filter
Top Products
54
Chapter 4 Engraving
4-2 Mounting a Workpiece
WARNING
Never inadvertently touch the computer or handy panel while performing this
task.
Unintended operation of the machine may result in injury.
CAUTION
Caution: cutting tool.
The cutting tool is sharp. To avoid injury, exercise caution.
When Using an Adhesive Sheet
Affix the adhesive sheet to the
workpiece table, then place the
workpiece on the adhesive sheet and
press down on it from above to secure
it in place.
On this machine, you can also use optionally available items to secure the workpiece in place: a center vise (ZV-23C)
or a vacuum table (ZV-23A). For detailed information about these optional items, contact your authorized Roland DG
Corp. dealer.
Workpiece
Workpiece table
Adhensive sheet