105
Appendix C
Configuring Microsoft Windows Network Settings
This section provides information on how to configure Microsoft Windows network
settings to connect to a 1700 reader using the In-Sight PC Host program. The steps listed
below and the example dialogs are specific to Windows NT 4.0. The exact steps required
may vary slightly in Windows XP, 2000, Me, and 98SE.
To configure Windows network settings:
1 Verify the PC has a TCP/IP protocol installed.
2 Close all programs on the PC except Windows NT.
3 Click Start, click Settings, and then click on the Control Panel shortcut to open the
Control Panel icon group.
4 Click the Network icon to open the Network dialog.
5 Select the Protocols tab (Figure C-0-1). If TCP/IP Protocol appears in this list, skip
steps 0 and 7.
Figure C-0-1: Windows Network dialog, Protocols tab
