Section 7: Native Mode Commands In-Sight
®
1700 Series Wafer Reader
72
7.4.4 ResetStats
ResetStats(<WafID>)
Reset all accumulated read statistics.
Inputs: WafID
Outputs: Status Code, # of bytes
EV RESETSTATS(A4)
1
0
7.5 Evaluate Extended Native Mode Commands
(Get)
The following commands are used to retrieve setting and read results from the Configs in
a wafer ID job. Each command returns a Status Code, the number of characters (in
bytes, including Carriage Returns and Line Feeds) in the output that follows, and the
results (in XML format).
The status codes for all Evaluate commands are:
STATUS CODE DESCRIPTION
1 The command was executed successfully.
0 Unrecognized command.
–2 The command could not be executed.
7.5.1 GetConfig
GetConfig(<WafID>,<Config>)
Returns the current settings for a Config.
Inputs: WafID, Config
Outputs: Status Code, # of bytes, Mark, Checksum, LightMode, LightPower, Orientation,
Row (Region), Column (Region), High (Region), Wide (Region), High (Char), Wide
(Char), FieldString, FieldDef, Color, Accept, Enable
