Section 6: System Settings In-Sight
®
1700 Series Wafer Reader
52
6.2 Version Information
The Info tab shows important information about your 1700 reader and its current
firmware and applet version. This information is needed if assistance is ever required
from Cognex Technical Support. The Online checkbox at the top-right of the Run tab
switches the reader between its online and offline modes of operation. For more
information about the Online checkbox, see Section 5.1.1. The Back hyperlink, located
below the Online checkbox, returns you to the Run tab.
Figure 6-1: Info Tab
6.3 Configuring Network Settings
The Network tab (Figure 6-2) configures an In-Sight system to be used on a network.
Figure 6-2: Network Tab
Use DHCP Server
The Use DHCP Server checkbox determines whether the 1700 reader uses DHCP
(Dynamic Host Configuration Protocol) on start up or if the values in the Network Settings
dialog configure TCP/IP.
NOTE This box should be checked only if a DHCP server is running on the local network. If the box is
checked and a DHCP server does not respond within 60 seconds, the reader will boot without
network support enabled.
