In-Sight
®
1700 Series Wafer Reader Section 2: Installing the 1700 Reader
13
2.4.1 Installing to a DHCP Network
The In-Sight 1700 reader is factory-configured for installation on an existing network with
a DHCP server. After connecting the CAT5 network cable and the Breakout, the DHCP
server will automatically detect the reader, configure its settings, and install it on the
network.
After adding a 1700 reader to a network using DHCP, it is recommended that DHCP is
disabled on the reader and that a static IP Address is assigned.
NOTE You will need to record the IP Address to connect to the reader from an Internet browser. To find
the IP Address that is assigned to the reader, run the In-Sight PC Host program, then open the
System menu and select Settings!
!!
!. From the Settings menu, select Network.
2.4.2 Installing to a Non-DHCP Network
A static IP Address must be assigned to the In-Sight 1700 reader before the reader will
be recognized on a network where a DHCP server is not available.
To install the In-Sight 1700 reader on a non-DHCP network:
1 Supply power to an In-Sight 1700, then open the In-Sight PC Host program.
2 From the In-Sight spreadsheet, press <ESC> to open the System menu.
Figure 2-5: PC Host System menu
