Agilent Technologies E4440-90189 Saw User Manual


 
Chapter 5 321
One-Button Measurement Functions
MEASURE (Spectrum Analysis Mode)
One-Button Measurement Functions
5.1.10 Intermod (TOI)
The third order intermodulation (TOI) measurement computes and displays the output
intercept point (IP3), and places markers upon the trace to indicate the measured signals
and third-order products. For more information see “Meas Setup (Intermod (TOI))” on page 423.
Key Path:
MEASURE
Remote Command:
Example: FETC:TOIN? or MEAS:TOIN? or READ:TOIN?
FETC:TOIN:IP3? or MEAS:TOIN:IP3? or READ:TOIN:IP3?
Measurement Results Available
Command Results Returned
:CONFigure:TOIN
:INITiate:TOIN
Not Applicable
:FETCh:TOIN?
:MEASure:TOIN?
:READ:TOIN?
Returns 6 scalar results, in the following order.
1. The worst case Output Intercept Power value in
dBm.
2. The worst case Output Intermod Point in Hz
3. The lower Output Intercept Power value in dBm
4. The lower Output Intermod Point in Hz
5. The upper Output Intercept Power value in dBm
6. The upper Output Intermod Point in Hz
:FETCh:TOIN:IP2?
:MEASure:TOIN:IP2?
:READ:TOIN:IP2?
Returns 12 scalar results, in the following order.
1. The worst case Output Intermod Point value in Hz.
2. The worst case Output Intermod Power value in
dBm.
3. The worst case Output Intercept Power value in
dBm
4. The lower base frequency value in Hz
5. The lower base power value in dBm
6. TheupperbasefrequencyvalueinHz
7. TheupperbasepowervalueindBm
8. The lower Output Intermod Point in Hz
9. The lower Output Intermod Power value in dBm
10. The lower Output Intercept Power value in dBm
11. The upper Output Intermod Power value in dBm
12. The upper Output Intermod Point in Hz
13. The upper Output Intercept Power value in dBm
:FETCh:TOIN:IP3?
:MEASure:TOIN:IP3?
:READ:TOIN:IP3?
Returns the worst case Output Intercept Power value
in dBm.