Agilent Technologies E4440-90189 Saw User Manual


 
338 Chapter5
One-Button Measurement Functions
Mode Setup (Spectrum Analysis Mode)
One-Button Measurement Functions
Power Stat CCDF and Burst Power are the only measurements available for this standard.
Key Type: 1 of N menu
Key Path:
Mode Setup, Radio Std
History: Added with PSA firmware revision A.02.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect]
See“RadioStd”onpage333.
Example: RAD:STAN BLUE
5.3.1.13 TETRA
Sets the specific parameters for the selected measurement (located under the
“MEASURE
(Spectrum Analysis Mode)”
key description) appropriate for industry standard TETRA. This
standard is only available for the Channel Power and ACP measurements.
Key Type: 1 of N menu
Key Path:
Mode Setup, Radio Std
History: Added with PSA firmware revision A.03.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect]
See“RadioStd”onpage333.
Example: RAD:STAN TETR
5.3.1.14 W-LAN
Accesses the W-LAN radio standards key menu to enable you to select a W-LAN standard.
Selecting a radio standard modifies spectrum analyzer settings for the CHP or CCDF
measurement activated under the
MEASURE menu.
5.3.1.14.1 802.11a Sets the specific parameters for the selected measurement (located
under the
“MEASURE (Spectrum Analysis Mode)” key description) appropriate for industry
standard 802.11a. This standard is only available for the Spectrum Emission Mask (SEM)
measurement.
Key Type: 1 of N menu
Key Path:
Mode Setup, Radio Std
History: Modified with PSA firmware revision A.04.00
Added with PSA firmware revision A.03.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect]
See“RadioStd”onpage333.