Filter
Top Products
Chapter 6 519
Programming Fundamentals
Programming Command Compatibility Across Model Numbers and Across Modes
Programming Fundamentals
Programming Command Compatibility
Across Model Numbers and Across Modes
Across PSA Modes: Command Subsystem Similarities
When you select different modes you get different sets of available
programming commands. That is, only the commands that are
appropriate for the current mode are available. Also, some commands
have the same syntax in different modes but have different ranges or
settings that are only appropriate to the current mode.
The following table shows which command subsystems are the same
across different modes. If there is no “X” by a particular subsystem,
then the set of available commands is different in those modes.
Command ranges or defaults may also be different. Refer to the
programming command descriptions in the documentation for each
mode for details.
Command Subsystem Same command set is
available:
SA mode compared with
the application modes:
W-CDMA, cdmaOne,
cdma2000, 1xEV-DO,
Basic, GSM, EDGE,
NADC, or PDC
Same command set is
available:
SA mode compared with
the application mode:
Phase Noise
IEEE common commands X X
ABORt X X
CALCulate
CALibration X X
CONFigure
COUPle not available in these
application modes
not available in this
application modes
DISPlay
FETCh
FORMat X
HCOPy X X
INITiate
INPut not available in these
application modes
X