Filter
Top Products
Chapter 6 503
Programming Fundamentals
SCPI Language Basics
Programming Fundamentals
SCPI Language Basics
This section is not intended to teach you everything about the SCPI
(Standard Commands for Programmable Instruments) programming
language. The SCPI Consortium or IEEE can provide that level of
detailed information.
Topics covered in this chapter include:
• “Creating Valid Commands” on page 504
• “Command Keywords and Syntax” on page 503
• “Special Characters in Commands” on page 505
• “Parameters in Commands” on page 506
• “Putting Multiple Commands on the Same Line” on page 508
For more information refer to:
IEEE Standard 488.1-1987, IEEE Standard Digital Interface for
Programmable Instrumentation. New York, NY, 1998.
IEEE Standard 488.2-1987, IEEE Standard Codes, Formats,
Protocols and Comment Commands for Use with ANSI/IEEE
Std488.1-1987.NewYork,NY,1998.
Command Keywords and Syntax
A typical command is made up of keywords set off by colons. The
keywords are followed by parameters that can be followed by optional
units.
Example: SENSe:FREQuency:STARt 1.5 MHZ
The instrument does not distinguish between upper and lower case
letters. In the documentation, upper case letters indicate the short form
of the keyword. The lower case letters, indicate the long form of the
keyword. Either form may be used in the command.
Example: Sens:Freq:Star 1.5 mhz
isthesameasSENSE:FREQ:start 1.5 MHz
NOTE The command SENS:FREQU:STAR is not valid because FREQU is neither
the short, nor the long form of the command. Only the short and long
forms of the keywords are allowed in valid commands.