Agilent Technologies E4440-90189 Saw User Manual


 
438 Chapter5
One-Button Measurement Functions
Meas Setup (Multi-Carrier Power—MCP)
One-Button Measurement Functions
Remote Command:
[:SENSe]:MCPower:CARRier:LIST:BANDwidth|BWIDth:[INTegration]<Hz>
[:SENSe]:MCPower:CARRier:LIST:BANDwidth|BWIDth:[INTegration]?
Example: MCP:CARR:BAND 3.5MHz,2.85MHz,3.84MHz
5.19.4 Offsets/Limits
Displays menu keys that enable you to configure the offsets and limits for the MCP
measurement.
Key Path:
Meas Setup
History: Added with firmware revision A.02.00
Remote Command:
There is no equivalent remote command.
5.19.4.1 Offset
Enables you to select the offset the menu keys will affect. Press
Offset until the letter of the
desired offset (A, B, or C) is underlined.
Key Path:
Meas Setup, Offset/Limits
Factory Preset: A
History: Added with firmware revision A.02.00
Remote Command:
There is no equivalent remote command.
5.19.4.2 Offset Freq
Sets the frequency difference between the center of the uppermost carrier and the center of
the upper element of the offset pair, as well as the frequency difference between the center
of the lower element of the offset pair and the center of the lowermost carrier. If you set the
frequency of any offset to 0 Hz, the offset is turned off and not included in the displayed
results.
Key Path:
Meas Setup, Offset/Limits
State Saved: Saved in instrument state.
FactoryPreset: 5MHz,10MHz,15MHz
Terminators: Hz, kHz, MHz, GHz
Default Terminator: Hz