Filter
Top Products
Chapter 5 437
One-Button Measurement Functions
Meas Setup (Multi-Carrier Power—MCP)
One-Button Measurement Functions
Remote Command:
[:SENSe]:MCPower:CARRier:LIST:WIDTh <Hz>
[:SENSe]:MCPower:CARRier:LIST:WIDTh?
Remote Command Notes:
• The position number of the each carrier width in the list sent
corresponds to the carrier number you are defining. For example: “5
MHz, 10 MHz, 5 MHz” defines six carriers. Carriers 1, 2, 4, and 5 are
defined as having power present whereas carriers 3 and 6 do not have
power present. If you need to change carrier 5, you must send all
carriers up to 5. Carrier 6 will remain unchanged. If you send more
values than the number of carriers specified using the
Carriers key, (in
this example, there are six carriers) they will be ignored.
• The query for this parameter returns the current value for all carriers
(with and without power present).
Example: MCP:CARR:LIST:WIDT 5 MHz,10 MHz,4 MHz,15 MHz,5 MHz,10 MHz
MCP:CARR:LIST:WIDT?
5.19.3.4.4 Carrier IntegBW
Press
Carrier IntegBW to define the integration bandwidth used to calculate the power in the
carriers.
Key Path:
Meas Setup, Carrier Setup, Configure Carriers
State Saved: Saved in instrument state.
SCPI Status Bits/
OPC Dependencies: The integration bandwidth is specified differently depending on the
radio standard selected. If
Mode Setup, Radio Std, 3GPP W-CDMA is selected
and the RRC filter is on, the actual integration bandwidth used will be the
displayed integration bandwidth multiplied by (1 + filter alpha).
Factory Preset: 3.84 MHz, 3.84 MHz, 3.84 MHz, 3.84 MHz
Terminators: Hz, kHz, MHz, GHz
Default Terminator Hz
Resolution:
Knob Increment: Span ÷ 50
Step Key
Increment: If
CF Step(Auto) is selected: span/10.
If CF Step(Man) is selected: CF Step
Range: 100Hzto20MHz
History: Added with firmware revision A.03.00.