Filter
Top Products
6-2
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-11350-01
Chapter 6 Configuring Radio Settings
Enabling the Radio Interface
Enabling the Radio Interface
The wireless device radios are disabled by default.
Note In Cisco IOS Release 12.3(8)JA there is no default SSID. You must create a Radio Service Set Identifier
(SSID) before you can enable the radio interface.
Beginning in privileged EXEC mode, follow these steps to enable the access point radio:
Use the shutdown command to disable the radio port.
Configuring the Role in Radio Network
Table 6-1 shows the role in the radio network for each device.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
dot11 ssid ssid Enter the SSID. The SSID can consist of up to 32 alphanumeric
characters. SSIDs are case sensitive.
Step 3
interface dot11radio { 0 | 1slot/port
}
Enter interface configuration mode for the radio interface. The
2.4-GHz radio is radio 0, and the 5-GHz radio is radio 1.
Step 4
ssid ssid Assign the ssid you created in Step 2 to the appropriate radio
interface.
Step 5
no shutdown Enable the radio port.
Step 6
end Return to privileged EXEC mode.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.
Table 6-1 Device Role in Radio Network Configuration
Role in Radio Network AP1200 AP1100 AP1130 AP1240
1300AP/
BR
Access point X X X X X
Access point (fallback to radio
shutdown)
XXXXX
Access point (fallback to repeater) X X X X X
Repeater X X X X X
Root bridge X – – X X
Non-root bridge X – – X X
Root bridge with wireless clients X – – X X
Non-root bridge with wireless clients X – – X X
Workgroup bridge X X X X X