Filter
Top Products
ACCESSORIES
C-2 C-2
POWER WAVE 655/R
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
OPTIONAL EQUIPMENT
FACTORY INSTALLED
There are no factory installed options available for the
Power Wave.
FIELD INSTALLED
Gas Guard Regulator (K659-1)
The Gas Guard regulator is available as an optional
accessory for Power Feed Robotic wire drive unit.
Install the 5/8-18 male outlet on the regulator to the
proper 5/8-18 female gas inlet on the back panel of the
wire drive. Secure fitting with flow adjuster key at top.
Voltage Sense Leads (K490-10, -25 or -50)
The voltage sense leads connect at the front of the
machine.
Cool Arc 40 (K1813-1)
* Water Flow Sensor (K1536-1)
Water cooled guns can be damaged very quickly if
they are used even momentarily without water flow-
ing. Recommend practice is to install a water flow
sensor such as on the water return line of the torch.
When fully integrated into the welding system, the
sensor will prevent welding if no water flow is present.
• Dual Cylinder Undercarriage, K1570-1*
*The Dual Cylinder Undercarriage, K1570-1 is not
compatible in combination with the Power Wave
Water Cooler K1767-1.
• Coaxial welding Cable, K1796