Filter
Top Products
REMOTE OUTPUT CONTROL OPTIONS
The Multi-Weld 350 is provided with a 6-pin remote
receptacle to permit use with the 25 ft.(7.6 m) K857 or
100 ft. (30.4 m) K857-1 Remote Output Control
options. The remote receptacle can also be used with
the LN-25 equipped with the K444-1 Remote Control
option. These remotes have single-turn resolution on a
Minimum to Maximum numbered dialplate.
CV MODE WIRE WELDING
The Converter in CV mode was designed for use with
an arc-powered wire feeder like the LN-25. The
Converter output is always “hot” when the mode switch
is not OFF. Therefore it is recommended that the LN-
25 model be equipped with the internal contactor in
order to have a “cold” electrode when the gun trigger is
released.
The CV mode recommended processes are positive
(+) polarity wire welding within the output capacity of
the Converter, including:
Flux Cored Arc Welding (FCAW)
Innershield: NS3M (5/64-3/32)
NR305 (.068)
Outershield: OS-70 (1/16-5/64)
OS-71 (.045-1/16)
MC-710 (.045-5/64)
Gas Metal Arc Welding (GMAW)
Carbon Steel: L50/56 (.030-1/16)
CC MODE STICK WELDING
AND GOUGING
The CC mode recommended processes are positive
(+) polarity stick and arc gouging within the output
capacity of single, or paralleled, Converters, including:
Shielded Metal Arc Welding (SMAW)
E6010/6011: FW5P/180 (3/32-1/4)
“fast-freeze”
E6013: FW37 (3/32-3/16)
“fill-freeze”
E7010/8010: SA85/70+ (3/32-7/32)
“fast-freeze” HT pipe
E7018/7028: JW LH70/3800 (3/32-5/32)
“low-hydrogen”
E7024/6027: JW1,3/2 (1/8-5/16)
“fast-fill”
Arc Air Carbon (AAC)
Gouging: Carbons (5/32-3/8)
B-5 B-5
OPERATION
MULTI-WELD 350
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC