Filter
Top Products
SEMIAUTOMATIC WELDING
ACCESSORIES
LN-7 OR LN-8 WIRE FEEDERS - Semiautomatic, con-
stant speed wire feeders. For CV operation only.
LN-23P WIRE FEEDER - This portable wire feeder is
capable of CV operation. K350-1 Adapter Kit is
required.
LN-25 WIRE FEEDER - The LN-25 with or without an
external contactor may be used with the Commander
300.
NOTE: Gas-shielded welding requires a Magnum Gun.
Gasless welding requires an Innershield Gun.
OTHER WIRE FEEDERS FOR THE
COMMANDER 300
• NA-3 Automatic Wire Feeder
• LN-742 Semiautomatic Wire Feeder
• Spool gun and K488 Module
HIGH FREQUENCY GENERATORS FOR
TIG APPLICATIONS
The K799 Hi-Freq Unit and the K930-ALL TIG Modules
are suitable for use with the Commander 500. The
Commander 500 is equipped with the required RF
bypass circuitry for the connection of high frequency
generating equipment. The high frequency bypass net-
work supplied with the K799 Hi-Freq Unit does NOT
need to be installed into the Commander 500.
The Commander 500 and any high frequency-generat-
ing equipment must be properly grounded. See the
K799 Hi-Freq Unit and the K930-AII TIG Module oper-
ating manuals for complete instructions on installation,
operation, and maintenance.
CONNECTION OF LINCOLN
ELECTRIC WIRE FEEDERS
ELECTRIC SHOCK can kill.
• Do not operate with panels open.
• Disconnect NEGATIVE (-) BATTERY
LEAD before servicing.
• Do not touch electrically live parts.
MOVING PARTS can injure.
• Keep guards in place.
• Keep away from moving parts.
• Only qualified personnel should install,
use or service this equipment.
C-3 C-3
ACCESSORIES
COMMANDER 500
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
WARNING