Filter
Top Products
70 Sun Fire 6800/4810/4800/3800 System Controller Command Reference Manual • October 2001
Description
Caution – This command requires that all domains are inactive (not running the
OpenBoot PROM, POST, or the Solaris operating environment) and the keyswitch be
set to off.
When you run this command from the platform shell without options, the platform
and domain values are set to the default values. When you run this command from
the domain shell without options, only the current domain values are reset to the
default values.
If a password is set, you will need to type the password in order to set the default
values. When you run this command from the platform shell, the password for the
platform shell is required. When you run this command from a domain shell, the
password for the domain shell is required. There are separate passwords for the
platform shell and each domain shell. In addition, this command also does the
following:
■ Sets the system controller to the default values. This command only resets the
system controller setting. It does not affect the domain’s configuration in the
OpenBoot PROM.
■ Erases all platform and domain configurations (platform).
■ Removes passwords (domain and platform).
Example
If you answer yes, the system controller is rebooted after the defaults are set.
If you answer no, the default values are not restored.
If a password is set for the platform shell, the password will be required.
CODE EXAMPLE 3-42 setdefaults Example
schostname:SC> setdefaults
You are about to reset all configuration data to default values.
All domain configurations, ACLs, passwords and data buffers will
be lost.
The system controller will be REBOOTED after the defaults are set.
Do you want to restore the default values and reboot now? [no]