Filter
Top Products
Chapter 3 System Controller Alphabetical Command Reference 83
Platform Contact The name of the person who is responsible for this system.
This name will be used by SNMP. Note that if SNMP is not
going to be enabled, this field is informational only.
Platform Location Location of the system (such as a room and/or the location
inside of the room). This information will be used by SNMP.
Note that if SNMP is not going to be enabled, this field is
informational only.
Trap Hosts IP address or name of the trap hosts (SNMP). You can define
multiple trap hosts.
Public Community String Community string for SNMP readers. The default is
P-public.
Note—For SNMP clients such as the Sun Management Center
3.0 software to access the system controller using SNMP, their
community strings should be set to the same value as the
value entered here.
Private Community String Community string for readers and writers. The default is
P-private.
Note—For SNMP clients such as the Sun Management Center
3.0 software to access the system controller using SNMP, their
community strings should be set to the same value as the
value entered here.
ACL for Domain A Access Control List (ACL). If the board name is listed in the
ACL for the specific domain, then you have permission to
perform addboard or deleteboard requests on that board.
Default value is to have all slots assigned to all domains.
• Typing the prefix-d deletes the slot from ACLs of this
domain.
• Typing a prefix of -a (add) adds a slot.
• Typing a dash ( - ) clears the entire list.
• Typing a + (plus sign) adds all.
• Pressing the Return key does not change the value
displayed inside [ ].
ACL for Domain B See the description for ACL for Domain A.
ACL for Domain C See the description for ACL for Domain A.
ACL for Domain D See the description for ACL for Domain A.
SC POST diag level The system controller boot parameters (diag level) can be set
to: off, min,ormax.
off
Only system board initialization code is run. No testing is
done. POST is not run.
TABLE 3-11 setupplatform Parameter Values (Continued)
Parameter Description