Filter
Top Products
80 Sun Fire 6800/4810/4800/3800 System Controller Command Reference Manual • October 2001
Example
Note – The default value displayed by the software for the OBP.* parameters is
<OBP default>.
If you enter an invalid value, the system controller displays “invalid entry” and
prompts you to enter a proper value (
TABLE 3-10). If a value is not specified, it retains
its current value. When an invalid entry is entered, it also lists the valid responses.
Typing a dash ( - ), clears the entry.
Current values are displayed in [ ].
TABLE 3-10 lists the setupdomain parameter
values.
CODE EXAMPLE 3-46 Variables for the setupdomain Command
schostname:A> setupdomain
Domain Boot Parameters
----------------
diag-level [default]:
verbosity-level [min]:
error-level [max]:
interleave-scope [within-board]:
interleave-mode [optimal]:
reboot-on-error [false]:
OBP.use-nvramrc? [<OBP default>]:
OBP.auto-boot? [<OBP default>]:
OBP.error-reset-recovery [<OBP default>]:
Log hosts
---------
Loghost [ ]:The hostname or the IP address of the loghost for this domain.
Log Facility [local0]: Definedby theSolaris operating environment syslogd in
/etc/syslog.conf.
SNMP
-----
Domain Description[]: A brief description for this domain (its function).
Domain Contact[ ]: The name of the primary domain administrator.
Trap Hosts [ ]: The
IP address of the loghost for this domain.
Public Community String [ ]:The community string for SNMP readers.
Private Community String [ ]: The community string for readers and writers.
schostname:
A>