Filter
Top Products
76 Sun Fire 6800/4810/4800/3800 System Controller Command Reference Manual • October 2001
setupdomain
Configures the domain.
Scope
domain shell
Syntax
setupdomain [-p part]...
setupdomain -h
Options/Parameters
-h displays help for this command.
-p part configures the specified information and has the following options:
■ bootparams configures the boot parameter information.
■ loghost configures the log hosts
■ snmp configures SNMP information.
TABLE 3-10 lists the parameter values for setupdomain. Note that for diag-level
definition and function of default and max are the same. Because the tests for mem1
and mem2 take a long time to run, use the default or max values. However, if you
suspect memory problems, then use the mem1 or mem2 values.
TABLE 3-10 Parameter Values for the setupdomain Command
Parameter Value Description
diag-level init Only system board initialization code is run. No
testing is done. This is a very fast pass through
POST.
quick All system board components are tested using few
tests with few test patterns.
default (default value) All system board components are tested with all tests
and test patterns, except for memory and Ecache
modules. For memory and Ecache modules, all
locations are tested with multiple patterns. More
extensive, time-consuming algorithms are not run at
this level. This is the same as max.