Barco 26-0503000-00 Router User Manual


 
14 MatrixPRO • 8x8 DVI Router • User’s Guide
NK==fåíêçÇìÅíáçå
About the MatrixPRO 8x8 DVI Router
^Äçìí=íÜÉ=j~íêáñmol=UñU=asf=oçìíÉê
The MatrixPRO=8x8 DVI Router is a DVI crosspoint switch supporting resolutions ranging
from VGA (640x480) to UXGA (1600x1200x60) — including all HDTV resolutions. Any
input can be routed to any combination of the 8 outputs. The unit is housed in a 2RU
chassis and is configured as an 8x8 router.
There are three ways that you can control the router:
Via front panel buttons and the integral menu display.
Via the interactive Control GUI, which is accessed through the rear panel’s
Ethernet connector.
Via the Encore Controller.
Note that user interface and system firmware upgrades can be installed in the field via the
system’s rear panel Ethernet and RS-232 connections.
cÉ~íìêÉë
The MatrixPRO=8x8 DVI Router includes the following features:
Front panel or GUI control.
One-to-one and one-to-many routing.
Input grouping, enabling you to create sub-groups of inputs and outputs.
Integrated test pattern generator.
For the selected output, “RGB Mute” feature blanks the output video while leaving
sync signals running to the monitor.
Input EDID (Extended Display Identification Data) control on a per-channel basis.
Input cable equalization control on a per-channel basis.
Menu-based setup and function selection.
Save and recall setups.
Reclocking TMDS (Transition Minimized Differential Signaling) functionality
ensures clean output signals.
Supports resolutions from VGA (640x480) to UXGA (1600x1200x60), including all
HD resolutions (e.g., such as 1920x1080).
Supports input cable lengths up to 20 meters, using high quality DVI cables.
Vertical interval switching mode, with selectable input channel lock source.
Local or external control via Ethernet or RS-232.
Optional remote switching panels via Ethernet communications.
Note
Signal quality cannot be guaranteed for cable lengths of 20
meters if lower quality DVI cables are used, or if cable
extenders are used.