Filter
Top Products
MatrixPRO • 8x8 DVI Router • User’s Guide 27
3. Installation
Signal Installation
páÖå~ä=fåëí~ää~íáçå
The figure below illustrates a sample MatrixPRO 8x8 DVI Router system diagram. Use this
figure for reference during the signal installation process.
Figure 3-2. MatrixPRO 8x8 DVI Router System Diagram (sample)
Use the following steps to install signals to/from the MatrixPRO 8x8 DVI Router:
1. Connect outputs from your available DVI sources to DVI inputs 1 through 8 on the
MatrixPRO router.
2. Connect MatrixPRO router outputs 1 through 8 to DVI inputs on your selected
destination devices.
3. (Optional) For Ethernet connections, a totally “local” network is recommended,
without IP connections to the outside world.
a. Using an Ethernet cable, connect the MatrixPRO’s Ethernet port to an
Ethernet Hub or Switch.
b. Connect Ethernet Hub or Switch to the desired peripheral Ethernet
devices, such as remote MatrixPRO panels or an Encore Controller.
4. (Optional) Connect the MatrixPRO’s RS-232 port to an external RS-232 device,
such as a PC.
Please continue with Chapter 4, “Operation
” on page 29.
Ethernet
Hub / Switch
From DVI
sources
MatrixPRO DVI
8x8 Router
To DVI
destinations
Inputs
Outputs
To Ethernet devices:
• ScreenPRO-II Controller
• Remote MatrixPRO panels
• Encore Controller
• PC
RS-232
To RS-232 Device:
• PC / Console Port