Filter
Top Products
3-4
Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide
78-18579-02
Chapter 3 Installing the Cisco ADE 2130 and 2140 Series Appliance
Mounting the Cisco ADE 2130 and 2140 Series Appliance in a 2-Post Rack
Caution To prevent injury, review the “Safety Guidelines” section on page 2-2 and the “Rack-Mounting
Configuration Guidelines” section on page 3-2 before installing the appliance in the equipment rack.
Step 1 Locate the equipment rack position you plan to install the appliance into.
Step 2 Verify that there are no obstructions and ensure that the equipment rack is stabilized.
Step 3 Position the appliance in the equipment rack, lining up the bracket holes on the appliance with the holes
on the rack, and secure it with two 10-32 x 1/2-inch rack screws (each side). You need two people to
install the appliance in the rack—one person to hold the appliance and one person to secure it to the rack.
Note The vertical spacing for the equipment rack is at least 1.75 inches (4.44 cm), with mounting
holes spaced 1.5 inches (3.81 cm) apart.
Step 4 Tighten the screws using a Number 2 Phillips screwdriver (each side).
2-Post Rack-Mount Hardware Kit
Figure 3-1 shows the bracket and screws that you need to install the Cisco ADE 2130 and 2140 Series
appliance in a 2-post rack. Table 3-1 describes the contents of the rack-mount hardware kit, Cisco part
number CADE-2U-BRACKETS.
Figure 3-1 2-Post Rack-Mount Kit
Table 3-1 2-Post Rack-Mount Kit
Item No. Description Quantity
1 Rack screw, 10-32 x 1/2-inch (1.27 cm) 4
2 Screw, hex head 6
3 L bracket 2
203369
1 2 3