Filter
Top Products
A-5
Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide
78-18579-02
Appendix A Troubleshooting
Reading the LEDs
–
Check the adapter card. There might be a problem with the adapter card. Refer to the
documentation that was included with your adapter card.
–
For warranty information, refer to the Cisco Information Packet publication that shipped with
your appliance or contact your customer service representative.
• The Cisco ADE 2130 and 2140 Series appliance powers up and boots only when a particular cable
is disconnected.
–
There might be a problem with the cable. For warranty information, refer to the Cisco
Information Packet publication that shipped with your appliance or contact your customer
service representative.
Reading the LEDs
There are several LEDs on the Cisco ADE 2130 and 2140 Series appliance. LEDs serve the following
purposes:
• Indicate that basic power is available to the appliance
• Guide you to a broken adapter card, or to one that has failed its diagnostics
• Give an indication that traffic is flowing through the adapter card to the appliance
The LEDs on the front panel of the Cisco ADE 2130 and 2140 appliance and corresponding adapter card
are aids for determining appliance and adapter performance and operation.
Front-Panel LEDs
Figure A-1 shows the locations of the appliance’s front-panel LEDs. Table A-1 describes these LEDs.
Figure A-1 Front-Panel LEDs
Table A-1 Front-Panel LEDs
LED Color State Description
Appliance Power
(location 1)
Green On Power on
Off Off Power off
A
B C
D
E
H
F
I
G
1 2 3 4 5
6
7
8
9
231190