Filter
Top Products
3-7
Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide
78-18579-02
Chapter 3 Installing the Cisco ADE 2130 and 2140 Series Appliance
Mounting the Cisco ADE 2130 and 2140 Series Appliance in a 4-Post Rack
Mounting the Cisco ADE 2130 and 2140 Series Appliance in a
4-Post Rack
Warning
When the appliance is installed in a rack and is fully extended on its slide rail, it is possible for the
rack to become unstable and tip over, which could cause serious injury. To eliminate the risk of rack
instability from extending the rail or in the event of an earthquake, you should affix the rack to the
floor.
This section contains the following topics:
• 4-Post Rack-Mount Hardware Kit, page 3-7
• Attaching the Inner Slide Rails to the Appliance, page 3-8
• Attaching the Outer Slide Rails to the Rack, page 3-9
• Installing the Appliance into the Rack, page 3-9
4-Post Rack-Mount Hardware Kit
Figure 3-4 shows the rails and brackets that you need to install the Cisco ADE 2130 and 2140 Series
appliance in a 4-post rack. Figure 3-5 and Table 3-2 on page 3-8 describes the contents of the rack-mount
hardware kit, Cisco part number CADE-2U-RAILS.
Figure 3-4 4-post Rails and Brackets
1 Rear-mounting bracket of outer slide rail 3 Inner slide rail
2 Front-mounting bracket of outer slide rail
231554
1
2
3