Filter
Top Products
SPI9000 Inverter Unit FI9 – FI14 User Manual
MN04004002E
For more information visit: www.EatonElectrical.com 5-9
September 2006
You can return to the Main menu any time by pressing Menu Button Left for 1 to 2 seconds.
The basic application package includes seven applications with different sets of parameters.
You will find the parameter lists in the application manual.
Once in the last parameter of a parameter group, you can move directly to the first parameter
of that group by pressing Browser button up.
See the diagram for parameter value change procedure in Figure 5-6.
Note: You can connect power to the control board by connecting the external power source
to the bidirectional terminal #6 on the OPTA9 board (see Chapter 4). The external
power source can also be connected to the corresponding +24V terminal on any option
board. This voltage is sufficient for parameter setting and for keeping the fieldbus
active.
Figure 5-6: Parameter Value Change Procedure
Keypad Control Menu (M3)
In the Keypad Control Menu, you can choose the control place, edit the frequency reference
and change the direction of the motor. You can enter the submenu level by pressing Menu
Button Right.
Note: There are some special functions that can be performed in menu M3:
Select the keypad as the active control place by pressing start for 3 seconds when the motor
is running. The keypad will become the active control place and the current frequency
reference and direction will be copied to the keypad.
Select the keypad as the active control place by pressing stop for 3 seconds when the motor
is stopped. The keypad will become the active control place and the current frequency
reference and direction will be copied to the keypad.
Copy the frequency reference set elsewhere (I/O, fieldbus) to the panel by pressing enter for 3
seconds.
Note: If you are in any other menu than menu M3, these functions will not work.
Basic parameters
P1 P18
Parameters
M2
G1 G8
Min Frequency
13.95 Hz
Min Frequency
13.95 Hz
Min Frequency
14.45 Hz
Input signals
G1 G8