Filter
Top Products
SPI9000 Inverter Unit FI9 – FI14 User Manual
5-30 For more information visit: www.EatonElectrical.com MN04004002E
September 2006
Expander Boards (S6.8.6)
The Expander boards submenu contains information about the basic and option boards. (See
Chapter Control unit)
You can check the status of each board slot by entering the Expander Boards page with Menu
Button Right. Use the Browser buttons to view the status of each board slot. The description
line of the keypad will display the type of the expansion board and the text “Run” is shown
below it. If no board is connected to the slot the text “no board” will be shown. If a board is
connected to a slot but the connection is lost for some reason, the text “no conn.” is
displayed. For more information, see Chapter 4.
For more information on expander board related parameters, see Page 5-30.
Figure 5-28: Expander Board Information Menus
Expander Board Menu (M7)
In the Expander board menu the user can 1) see the expander boards connected to the
control board and 2) see and edit the parameters associated with the expander boards.
Go to the next menu level (G#) with Menu Button Right. At this level, you can browse through
slots A to E with the Browser buttons to see which expander boards are connected to the
control board. On the lowermost line of the display, you will also see the number of
parameters associated with the board. You can view and edit the parameter values as
described on Page 5-8. See Table 5-16 and Figure 5-29.
Expander boards
56.8.6
State
E6.8. 6. .
E1 E5 E1 E2
A:OPTA1
E6.8. 6.
Run
B:OPTA2
E1 E2
Software version
10001.0