Filter
Top Products
SPI9000 Inverter Unit FI9 – FI14 User Manual
MN04004002E
For more information visit: www.EatonElectrical.com 6-3
September 2006
● Check in Monitoring Menu M1 that the value of Output Frequency changes
according to the change of frequency reference.
● Press the STOP button on the keypad.
9. Perform the start-up tests without the motor being connected to the process. If this is
not possible, make sure that each test can be done safely prior to performing it. Inform
your co-workers of the tests.
● Switch off the DC supply voltage and wait until the drive has stopped as advised on
Page 6-1, Safety Precautions.
● Connect the motor cable to the motor and to the motor cable terminals of the
inverter.
● Make sure that all Start/Stop switches are in Stop positions.
● Switch the supply voltage ON.
● Repeat Test A or B in step 8.
10. Connect the motor to the process (if the start-up test was performed without the motor
being connected). Inform our co-workers of the tests.
● Before running the tests, make sure that this can be done safely.
● Repeat Test A or B in step 8.