Filter
Top Products
SPI9000 Inverter Unit FI9 – FI14 User Manual
MN04004002E
For more information visit: www.EatonElectrical.com 5-19
September 2006
Figure 5-14: Parameter Copy to Keypad
Download parameters to drive (From keypad, S6.3.3)
This function downloads one or all parameter groups uploaded to the keypad to a drive
provided that the drive is in STOP status.
Enter the To Keypad page (S6.3.2) from the Parameter Copy menu. Pressing the Menu Button
Right takes you to the edit mode. Use the Browser buttons to select either All Parameters, All
but Motor Parameters or Application Parameters and press the ENTER button. Wait until
“OK” appears on the display.
The procedure to download the parameters from keypad to drive is similar to that of from
drive to keypad. See Figure 5-14.
Automatic Parameter Backup (P6.3.4)
On this page you can activate or inactivate the parameter backup function. Enter the edit
mode by pressing Menu Button Right. Select Yes or No with the Browser buttons.
When the Parameter backup function is activated control keypad makes a copy of the
parameters of the presently used application. When applications are changed, you will be
asked if you wish the parameters of the new application to be uploaded to the keypad. If you
want to do this, press the ENTER button. If you wish to keep the copy of the parameters of the
previously used application saved in the keypad, press any other button. Now you will be
able to download these parameters to the drive following the instructions given in Chapter
Copy Parameters on Page 5-18.
If you want the parameters of the new application to be automatically uploaded to the
keypad, you have to do this for the parameters of the new application once on page 6.3.2 as
instructed. Otherwise the panel will always ask for the permission to upload the parameters.
Note: Parameters saved in the parameter settings on page S6.3.1 will be deleted when
applications are changed. If you want to transfer the parameters from one application
to another, you have to upload them first to the keypad.
Up to keypad
Change Value
Up to keypad
All param.
Select
56.3.2
Up to keypad
OK
56.3.2
Copy Parameters
Select
56.3
Up to keypad
Wait. . .
56.3.2
56.3.2
P1 P4
Confirm
Cancel