Filter
Top Products
SPI9000 Inverter Unit FI9 – FI14 User Manual
5-24 For more information visit: www.EatonElectrical.com MN04004002E
September 2006
Default page in the operating menu (P6.6.2)
Here you can set the location (page) in the Operating menu (in special applications only) to
which the display automatically moves to when the set Timeout Time (see below) has expired
or the power is switched on to the keypad.
See how to set the Default page in Figure 5-21.
Timeout Time (P6.6.3)
The Timeout Time setting defines the time after which the keypad display returns to the
Default page (P6.6.1).
Enter the edit mode by pressing Menu Button Right. Set the desired timeout time and
confirm it with the ENTER button. You can return to the previous menu at any time by
pressing Menu Button Left.
Figure 5-22: Timeout Time Setting
Note: If the Default page value is 0, the Timeout Time setting has no effect.
Contrast Adjustment (P6.6.4)
In case the display is unclear, you can adjust its contrast through the same procedure as for
the timeout time setting (see above).
Backlight Time (P6.6.5)
By giving a value for the Backlight time, you can determine how long the backlight stays on
before going out. You can select any time between 1 and 65535 minutes or “Forever.” For the
value setting procedure, see Timeout Time above.
Confirm Change
Cancel
Timeout time
90 s
P6.6.3
Timeout time
90 s.
Timeout time
P6.6.3 P6.6.3
60 s.