Filter
Top Products
ERX 8.0.x Hardware Guide
1. Determine the part number and serial number of the component. For
instructions
, see “Locating Component Serial Numbers ” on page 152.
2. Obtain a Return Materials Authorization (RMA) number from the Juniper
Networks Tech
nical Assistance Center (JTAC). See “Information You Might
Need to Supply to JTAC” on page 153.
Provide the fo
llowing information in your e-mail message or during the
telephon e call:
Part number a
nd serial number of component
Your name, or
ganization name, telephone number, and fax number
The shipping
address for the replace ment component, including contact
name and phone number
Description of t he failure
The support representative validates your request and issues an RMA number
for return of the component.
3. Pack the routing node or component for shipment, performing the procedure
described in “Returning Products for Repair or Replacement” on page 154.
Locating Component Serial Numbers
Before contacting Juniper Networks to request a Return Materials Au tho rization
(RMA), you m
ust find the serial number on the chassis or component. To list all the
chassis modules and their serial numbers, enter the following command:
host1#show
hardware
You can also find the serial numbe rs on the modules. ID stickers are
usually ap
plied near the ejector. See Figu re 57.
Fan trays a
re not listed in the show hardware command output. ERX-7xx model
and ERX-14xx model fan trays have stickers on the faceplate. For the ERX-310
router, you must remove the fan tray to view the serial number ID sticker.
152 Locating Component Serial Numbers