Filter
Top Products
Accessing ERX Routers
To connect a console directly to the system:
1. ConnectthefemaleDB-9connectortotheRS-232portonthesystem’sSRP
I/O module. Se
eFigure36.
Figure 36: Management Ports for ERX Routers
2. Connect the crossover adapter connector to your PC’s serial port.
3. Power up
the system.
When you power up the system, the CLI appears on your console’s screen.
The syst
em is now in User Exec mode, and you can begin configuration. For
more informatio n on using the CLI and configuring the system, see the JUNOSe
System Basics Configuration Guide.
NOTE: Direct access through the RS-232 serial port enables you to monitor the
system while it boots.
Console Port Setup 79