Filter
Top Products
Installing Modules
Verifying the Installation
To verify that the ins tallation is complete:
1. After you have cabled the system for power, as described in “Cabling ERX
Routers” on pa
ge 53, turn on the power switches.
The system reboots.
2. Issue the show redundancy command, and verify that the display shows
the redundancy hardware.
Configuring Line Module Redundancy
For information about configuring line modu le redundan cy, see JU N O S e System
Basics Confi
guration Guide, Chapter 6, Managing M od ules .
The Next Step
After you install the modules, you can connect cables to the system.
See “Cabling
ERX Routers” on page 53.
The Next Step 51