Filter
Top Products
THEORY OF OPERATION
E-4 E-4
PIPELINER® 200
BATTERY, STARTER, ENGINE
ALTERNATOR, OIL, & TEMPERATURE
SWITCH CIRCUITS
The 12VDC battery powers the starter motor and,
through the ignition switch, the engine ignition circuitry
(gas models only), the engine alternator, the engine
control protection modules and associated circuits.
See the appropriate block diagram. These engine con-
trol and protection modules monitor engine oil pres-
sure, coolant temperature and engine RPM. The sys-
tem shuts the engine down in the event of a sudden
low oil pressure or high coolant temperature. A warn-
ing light on the control panel provides fault codes, or on
some models the engine fault light will glow.
The engine idle control (solenoid, throttle plates or
actuator) is mechanically connected to the engine.
When welding current or auxiliary power (120VDC) is
drawn through the current sensing P.C. board a small
voltage signal is sent to the engine control circuitry.
This signals the engine control circuitry to increase the
engine RPM. This is accomplished in a variety of
methods depending upon the engine and con-
trol/protection being used.
When the welding or auxiliary load is removed a preset
time delay of about 15 seconds starts. After approxi-
mately 15 seconds of “no load” the engine con-
trol/protection circuitry returns the engine to low idle
RPM.
FIGURE E.4 — ENGINE CONTROL
ENGINE
IDLER
SOLENOID
12 VOLT
BATTERY
ENGINE
PERKINS DIESEL
F
ROM CURRENT
SENSING P.C. BOARD
IDLER
SWITCH
IDLER/ENGINE
PROTECTION
P.C.BOARD
ENGINE
FAILURE
LAMP
ENGINE
HOUR
M
ETER
F
UEL
PUMP
FUEL
SOLENOID
O
IL
GAUGE
OIL
SENSOR
SWITCH
TEMP.
S
ENSOR
S
WITCH
TEMP.
GAUGE
STARTER
MOTOR
E
NGINE
A
LTERNATOR
GLOW PLUGS
TO
BATTERY
IGNITION
S
WITCH
COUPLEDTO
GENERATOR
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC