Filter
Top Products
INSTALLATION
A-2 A-2
PIPELINER® 200D KUBOTA
TECHNICAL SPECIFICATIONS - PIPELINER® 200D KUBOTA (K6090-11)
INPUT - DIESEL ENGINE
RATED OUTPUT @ 104°F(40°C) - WELDER
HEIGHT WIDTH DEPTH WEIGHT
45.50
(2)
in. 24.00 in. 68.00 in. 1302 lbs.
(1156 mm) (610 mm) (1727 mm) (592 kg)
RATED OUTPUT @ 104°F(40°C) - GENERATOR
DESCRIPTION RATED DC OUTPUT Duty DC CURRENT RANGE
VOLTS @ RATED AMPS CYCLE Fine Adjustments in each Range
200 Amp DC Welder
LINCOLN PLUS RATING
40V @ 200A
All Copper Windings NEMA RATING 28V @ 200A 60% 40-300 Amps
Pure DC Power Generator
Auxiliary Power
(1)
1.75 kW 15 Amps @ 120V DC @ 35% Duty Cycle
PHYSICAL DIMENSIONS
(1) Output rating in watts is equivalent to volt-amperes at unity power factor. Output voltage is within ± 10% at all loads up to rated capacity.
When welding, available auxiliary power will be reduced.
(2) Height is to the top of exhaust elbow. Case height is 40.9 in.(1039mm).
Make/Model Description Speed (RPM) Displacement Starting Capacities
System
4 Cylinder
4 Cycle 134.1 cu. in
12VDC battery
Fuel: 15 gal
Naturally Aspirated (2.2 ltrs) (Group 45, 650 57 L
Kubota Water-Cooled High Idle 1600 cold crank amps)
V2203M Diesel Engine Low Idle 1400 Bore x Stroke
1.4 KW
Starter Oil: 8.0 Qts.
Cast Iron Cylinder, Full Load 1600 40 A. Alternator 7.6 L
Block/Crankcase 3.43” x 3.64” w/ built in reg. 9.5 Qts
.
27.8HP @1600 RPM
9.0 L
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC