Filter
Top Products
TROUBLESHOOTING & REPAIR
F-61 F-61
LN-9 Wire Feeder
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
PROCEDURE
1. Remove input power to the LN-9 wire feeder.
2. Using the Phillips head screw driver, remove
the screws holding the left side cover assem-
bly.
3. Lift the cover assembly.
4. Using the slot head screwdriver, remove the
two screws from the tach assembly cover.
See Figure F.21. Remove the cover.
TACH PC BOARD REMOVAL AND REPLACEMENT (continued)
FIGURE F.21 – TACH ASSEMBLY COVER SCREWS
TACHASSEMBLY
COVER
SCREWS