Filter
Top Products
F-66 F-66
LN-9 Wire Feeder
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
DRIVE MOTOR REMOVAL AND REPLACEMENT (continued)
11. Remove the three screws that hold the glas-
tic mounting to the LN-9 floor assembly.
See Figure F.26.
NOTE: Four- roll drive units have nuts and wash-
ers also. Screw heads are located under the
Mylar insulator.
12. Remove motor leads #626, #627, #539,
#541, #527 and #528 from their terminal
locations. Remove the green motor ground
lead. See
Figure F.25.
Free the leads from
the harness to allow movement of the motor.
Cut or untape any necessary harness ties.
FIGURE F.26 – GLASTIC MOUNTING SCREWS
NUTS AND
WASHERS
(4-ROLL
FEEDERS)