Filter
Top Products
3... INTERFACE MODULES
USING THE OMP-MODL3-10
NEXT and SELECT
The NEXT and SELECT buttons are for User control of the liquid
crystal display (LCD) information displays. Pressing NEXT will
advance the LCD to the next menu item at the current menu level.
Pressing the SELECT button selects that menu item and a new level
of menus or results are displayed.
A detailed explanation of the operation of the NEXT and SELECT
buttons is covered in a later section on the Display.
ENABLE Button:
The ENABLE button duplicates the functions of the ENABLE button
located on the end of the MLCPU-1 module (discussed in prior
section MLCPU-1 Module).
STOP Button:
The STOP button duplicates the functions of the STOP button
located on the end of the MLCPU-1 module (discussed in prior
section MLCPU-1 Module).
As discussed in that section, memory can be cleared by holding this
button down for approximately 10 seconds. Memory can also be
cleared through a menu sequence utilizing the NEXT and SELECT
buttons on loggers equipped with the ML-DISP module. See Display
section following.
RESET Button:
The RESET button duplicates the functions of the RESET button
located on the end of the MLCPU-1 module (discussed in prior
section MLCPU-1 Module).
3-Button System Initialization:
A complete initialization of the logger that will clear data memory
and program memory can be performed using the ENABLE, STOP
and RESET buttons. This sequence (discussed in prior section
MLCPU-1 Module) can be performed using the buttons located on
the ML-DISP module as well.
Display
An extended temperature range 2-line by 16 character liquid crystal display
(LCD) is provided. Information ranging from Operational Mode to System
Status to Alarm Messages to signal readings can all be displayed on the
LCD. The LCD is continually ON. Information to be displayed is controlled
by a User via the SELECT and NEXT front panel buttons.
Additionally, alarm messages will be automatically displayed on the LCD
when User pre-programmed conditions are met. These messages and