Filter
Top Products
5... HYPERCOMM™ COMMUNICATIONS
USING THE OMP-MODL 5-11
Reported information includes:
UNIT INFORMATION:
LOGGER VERSION:
Specifies the logger version number.
UNIT NAME AND UNIT ID:
User programmable information for tracking of equipment
(see procedure for setting described above).
UNIT TIME:
The current date and time on the logger internal real time
clock.
PROGRAM NET INFORMATION:
NAME AND DESCRIPTION:
Information that has been User programmed in the Global
Icon from within HyperNet.
CURRENT OPERATIONAL STATE:
OPERATIONAL MODE:
Indicates if the unit is Enabled, Stopped, Idle, etc.
REMAINING MEMORY:
Specifies the percentage and Kilobytes of data memory still
available. When using this number for estimating available
logging time consideration must be made for varying
sampling rates and data storage formats.
# OF SAMPLES LOGGED:
Specifies the number of samples recorded to memory.
SYSTEM SUPPLY VOLTAGE
Displays the logger supply voltage. If internal batteries are
installed in the logger and an external power supply is also
connected, the displayed Supply Voltage refers to the
greater of the two.
FYI: The displayed Supply Voltage is
measured at an internal node on the power
supply circuitry. Displayed battery voltage is
the voltage of the internal batteries .
External supply voltage will be
approximately 2 volts higher than indicated.
If the Input Range Jumper (see MLCPU-1
section of Chapter 2) is set to HI, the
External supply voltage will be
approximately 3.5 volts higher than
indicated.