I – 1
INDEX
A
AC power cord ................................................ 1-2
AC power inlet................................................. 1-4
Accessories..................................................... 1-2
Adjusting the blade length............................. 2-13
Adjusting the registration-mark reading sensor (1)
4-17
Adjusting the registration-mark reading sensor (2)
4-18
Adjusting the Sensitivity of the Registration-Mark
Sensor........................................................ 4-21
Aligning the coordinate axes......................... 4-23
Aligning the push rollers.................................. 2-9
An error message was displayed.................... 6-5
AUTO PRE-FEED........................................... 4-5
Auto-registration-mark-reading settings.......... 4-8
B
Blade-tip initial position setting........................ 5-2
C
Checking the wear rate................................. 4-38
Circle-command resolution setting.................. 5-3
Clearing the buffer memory .......................... 4-22
Clearing the total distance (wear rate).......... 4-40
COND. ............................................................ 1-5
Condition-list printing .................................... 4-43
Connecting to your computer.......................... 2-2
Control panel................................................... 1-5
Cutter blade (CB09UA)................................... 1-2
Cutter plunger ................................................. 1-2
Cutter-pen construction................................. 2-12
Cutting demo................................................. 4-45
Cutting Force Test Cutting............................ 4-46
Cutting mat...................................................... 1-3
Cutting/plotting using the buffer memory (COPY
function) ..................................................... 4-32
D
Description of special functions ............... 5-2, 5-5
Display language setting................................. 5-5
Displaying the effective cutting area ............... 3-9
Distance adjustment ..................................... 4-25
Drawing origin point ...................................... 4-10
Dump mode ...................................................4-44
E
Enabling/disabling blade wear detection .........5-3
Enabling/disabling PEN UP MOVE..................5-3
Enabling/disabling the “:” and “;” commands ...5-2
Enabling/disabling the home sensors..............5-3
Enabling/disabling the media sensors .............5-3
ENTER.............................................................1-5
Error messages in GP-GL command mode.....6-6
Error messages in HP-GL command mode.....6-7
Expanding the cutting/plotting area ...............4-29
External dimensions ....................................... A-4
G
GP-GL ERROR................................................6-6
Grit roller..........................................................1-3
H
HP-GL ERROR................................................6-7
I
Indicator lamp ..................................................1-5
Interface settings ...........................................4-35
L
Loading the medium ........................................2-4
Loading the roll medium ..................................2-5
M
Main specifications ......................................... A-2
Media cutter.....................................................1-2
Media set lever ................................................1-3
Medium and registration-mark position............4-9
Menu tree........................................................ A-5
Mirroring.........................................................4-31
Model ID response...........................................5-2
Moving the pen ................................................3-9
Moving the pen carriage in +100 mm steps...3-12
Moving the pen while raised or lowered in
response to the “W” command (when the
COMMAND setting is GP-GL)......................5-2
