4 – 34
4.16 Sorting Settings
This function sorts and cuts or plots the cutting/plotting data stored in the buffer memory to minimize the
amount of medium feed required. This is useful for data requiring a large number of movements on the
drawing with the pen raised. If the data received has been sorted using the application software, sorting
the data using the cutting plotter may require additional time. Turning this function off may speed up the
process.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the sorting setting menu.
Press the or key to select “ON” or “OFF,” and then press the (ENTER)
key to confirm. To cancel the selection, press the (NEXT) or (PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
Step
1
Step
2
Step
3
Step
4
• This setting is retained in the memory even when the
power is turned off.
• If data for which the cutting/plotting sequence has been
set using the application software is received, the cut-
ting/plotting sequence may be changed if this function is
set to “ON.” The function should be set to “OFF” in this
case.
FEED
MOVE TO R. MARK
AUTO PRE FEED
TANGENTIAL
AUTO REG. MARK
CLEAR BUFFER
AXIS ALIGNMENT
DISTANCE ADJUST
PAGE LENGTH
PLOT AREA
EXPAND
ROTATE
MIRROR
COPY
SORT
RS-232C
COMMAND
BLADE WEAR SETUP
PEN UP/DOWN
TEST MODE
PEN UP SPEED
OFFSET FORCE
OFFSET ANGLE
STEP PASS
INIT. DOWN FORCE
LENGTH UNIT
SORT
SORT OFF
CHECKPOINT
