3 – 8
Setting FORCE
Sets the pressure applied by the cutter pen during cutting. Set the FORCE value based on the guidelines
in the table entitled “Optimal Cutting Conditions for Each Media Type” on page 3-5.
Press the (COND.) key in READY mode to display the cutter-pen conditions.
Select the setting area (condition number) to be set, and then use the or key to move the symbol
to the position shown below.
Press the or key to select the value to be changed in the range specified below.
Tempo 600: “1” to “31”
Press the (ENTER) key to confirm the selection. If other conditions are to be set, press the or
key to move the symbol to the parameter to be set.
Setting SPEED
Sets the speed used for cutting. Set the SPEED value based on the guidelines in the table entitled “Opti-
mal Cutting Conditions for Each Media Type” on page 3-5.
Press the (COND.) key in READY mode to display the cutter-pen conditions.
Select the setting area (condition number) to be set, and then use the or key to move the symbol
to the position shown below.
Press the or key to select the value to be corrected in the range specified below.
Tempo 600: “1” to “60”
For all cutting plotters, “1” to “10” is in increments of 1, and “10” to “40” or “60” is in increments of 5.
Press the (ENTER) key to confirm the selection. If other conditions are to be set, press the or
key to move the symbol to the parameter to be set.
Step
1
Step
2
Step
3
Step
1
Step
2
Step
3
2 0 9 U + 1 14 3 0 2
2 0 9 U + 1 1 4 30 2
