4
4
FUNCTION SETTINGS AND OPERATIONS
4.1 PAUSE Menu List ........................................................................4-2
4.2 Reading the Auto Registration Marks.............................4-3
4.3 Setting the FEED function.......................................................4-4
4.4 Setting AUTO PRE-FEED .........................................................4-5
4.5 Setting TANGENTIAL Mode.....................................................4-6
4.6 Auto-Registration-Mark-Reading Settings .....................4-8
4.7 Clearing the Buffer Memory..................................................4-22
4.8 Aligning the Coordinate Axes..............................................4-23
4.9 Distance Adjustment...............................................................4-25
4.10 Setting the PAGE LENGTH ....................................................4-27
4.11 Setting the Cutting/Plotting Area........................................4-28
4.12 Expanding the Cutting/Plotting Area.................................4-29
4.13 Rotating the Coordinate Axes..............................................4-30
4.14 Mirroring ......................................................................................4-31
4.15 Cutting/Plotting Using the Buffer Memory
(COPY Function)............................................................................4-32
4.16 Sorting Settings ........................................................................4-34
4.17 Interface Settings .....................................................................4-35
4.18 Setting the Format of Data to be Received .....................4-36
4.19 Blade Wear Detection (When Blade Wear Setup is On) ......4-38
4.20 Raising and Lowering the Pen.............................................4-42
4.21 TEST Mode..................................................................................4-43
4.22 Setting the PEN UP SPEED...................................................4-48
4.23 Setting the OFFSET FORCE (Initial Cutting Force) ..........4-49
4.24 Setting the OFFSET ANGLE .................................................4-50
4.25 Setting the STEP PASS...........................................................4-51
4.26 Setting the Initial Down Force..............................................4-52
4.27 Setting the LENGTH UNIT......................................................4-53
