Filter
Top Products
138 Chapter2
Instrument Functions: A - L
File
Instrument Functions: A - L
Remote Command:
:MMEMory:STORe:SCReen <‘file_name’>
:MMEMory:STORe:STATe 1,<‘file_name’>
:MMEMory:STORe:TRACe <label>,<‘file_name’>
This command is not available when you are outside the Spectrum Analysis mode and
working in optional measurement modes.
:MMEMory:STORe:LIMit LLINE1|LLINE2,<‘file_name’>
:MMEMory:STORe:CORRection ANTenna|CABLe|OTHer|USER,<‘file_name’>
:MMEMory:STORe:RESults <‘file_name’>
*SAV <register#>
Remote Command Notes: For the MMEM:STOR:TRAC <label>,<“file_name”> command:
Trace labels are: TRACE1|TRACE2|TRACE3|ALL
Thefilenamemusthaveafileextensionof.TRCor.CSV.Thefile
extension determines whether a trace is stored (.CSV), or a trace with
its state (.TRC), are stored.
The <‘file_name’> must include the complete path, for example
‘C:\MYTRACE.TRC’. Lowercase characters are interpreted as uppercase.
These commands will fail if the <‘file_name’> already exists.
For the MMEM:STOR:LIM LLINE2,”C:mylimit.lim” command, there is no
short form for parameters LLINE1|LLINE2.
Example: MMEM:STOR:STAT 1,’C:\mystate.sta’ saves the current instrument
state to the specified file name. The .sta extension is required.
*SAV saves the current instrument state to a file name REGxxx,wherexxx
= the register number. The available register numbers are 0 to 127.
MMEM:STOR:SCR ‘C:\myscreen.gif’ Thefilemusthavea.gif or .wmf
file extension. The specified file extension determines which file format the
instrument will use to save the image. Only
Bitmap and Metafile are
available (not
Reverse Bitmap and Reverse Metafile).
MMEM:STOR:TRAC TRACE3,’C:\mytrace.trc’ Saves trace 3 to the trace +
state file C:\MYTRACE.TRC
MMEM:STOR:CORR ANT, ‘A:TEST1.AMP’ saves the current antenna
correction to the specified file name. The .amp extension is required.
MMEM:STOR:LIM LLINE2,’C:mylimit.lim’ saves the current limit line
two data set to the specified file name. The .lim extension is required.
MMEM:STOR:RES ‘A:ACP.CSV’ saves the current ACP measurement
results to the specified file name. The .csv extension is required.