Filter
Top Products
Chapter 5 319
One-Button Measurement Functions
MEASURE (Spectrum Analysis Mode)
One-Button Measurement Functions
wherePavg=averagepower,nisthestarttracepoint,m=thestoptracepoint,andp=the
trace point amplitude power in dBm.
Figure 4 shows an example of the results obtained when measuring a Bluetooth™ signal and
with a user-defined burst width.
Figure 4 Burst Power Measurement Results
NOTE The analyzer defaults to zero-span mode and the sweep time is set to capture
at least one burst. The sweep time can be changed by pressing Sweep, Sweep
Time.
Pressing
Meas Setup after Burst Power has been selected displays the burst power
measurement setup menu. Pressing Meas Control after Burst Power has been selected
displays the burst power control menu, where you can pause or restart a measurement, or
toggle between continuous and single measurement.
Key Access:
MEASURE
NOTE The measurements described above are those available in SA mode (see Mode
key). Other measurements are available in other modes if an optional
personality is installed.
Key Path:
MEASURE