Filter
Top Products
Page 6 - 26
Applications
© GBC Films Group April 2000
F - 160 CE Operation and Maintenance Manual
Parameter Chart 11 - Encapsulation
TEMPERATURE
GAP & PRESSURE
MOTOR DIRECTION & SPEED
TOP TEMP. BOT. TEMP.
PRESSURE
GAP
SPEED
FWD
REV.
GO
GO
= Panel
SOLID
FLASHING
= Footswitch
PULL ROLL SETTINGS
NOTES
N / A
1/4 Turn
1/2 Turn
3/4 Turn
PRESSURE
MATERIALS
UPPER UNWIND :
LOWER UNWIND :
SUBSTRATE :
PRINTS :
3 mil Octiva Gloss N / A
Any type
240
240
0
0 - 7
Upper and lower unwind material may be sibstituted with similar products. Top and bottom temperature will
be dependent on film thickness . Pressure may vary acording to the output. Speed will be dependent on
image type. Pull roll pressure will very between 1/2 turn and 3/4 turn, depending on the film output quality.
Because the process is described from the front of the laminator, motor direction is FWD.
DOWN
UP
3 mil Octiva Gloss