Filter
Top Products
Page 1 - 4
Safety F - 160CE Operation and Maintenance Manual
© GBC Films Group April 2000
1.4 Emergency stop
The laminator is equipped with four emergency
stops ( E-STOP ) located at the front of the cabinets and
the rear of the cabinets. Refer to Figure 1.4.1 Emergency
stops.
Figure 1.4.1 Emergency stops
Front
Rear
Emergency stops
Emergency stops
To engage an E-STOP, press down on any of the
four. Any E-STOP, when engaged, removes power to
the laminator. Refer to Figure 1.4.2 Engage an E-STOP.
Figure 1.4.2 Engage an E-STOP
Push
INFORMATION
The machine will only operate if all four
E-STOPS are in the unlatched position.
To continue operation, all E-STOPs must be in
the unlatched position. To reset, twist the E-STOP 1/4
turn clockwise. Refer to Figure 1.4.3 Reset the E-
STOP.
Figure 1.4.3 Reset the E-STOP
Unlatch